A Cornucopia of Delightful Cannabis Cultivars

[Costanza]

I use a washer tray as well now. I’ve been trying to find a better riser than the round elevators I use in the saucers. Haven’t quite got it nailed yet. I need four corner supports.

I’m close…View attachment 85925

I was just looking at those same risers I’m gonna get my buddy to 3d print some

 

[Costanza]

Check out the white plastic egg crate grids for drop ceilings. They'll be near the replacement drop ceiling panels at any big box hardware store (Menard, lowes, or home depot in the USA, idk what you've got in canada). It works great for a 1/4" air gap and come in 2' x 4' sheets i just cut to fit my trays.

thanks for this I’m gonna go to Lowe’s this weekend and see what I can find

 

[Zen_seeker]

Check out the white plastic egg crate grids for drop ceilings. They'll be near the replacement drop ceiling panels at any big box hardware store (Menard, lowes, or home depot in the USA, idk what you've got in canada). It works great for a 1/4" air gap and come in 2' x 4' sheets i just cut to fit my trays.

I already had the plastic walkway so just reused it, for now. The problem is the trays built in drain channels. They don’t go all the way to the edge so my platform sags at the corners. The soft pots can tilt. I need to make 4 plastic supports. Just haven’t gotten around to measuring the height yet.

If I’m not happy with the result I’ll go your route. I’ve seen a few others use it as well. It would be nice if it was the same height as the channel walls. Then a custom cut would be a nicer fit.

The elevators work fine for now and I’ll use them in this runs SCROG.

 

[Costanza]

Day 68 on the autos
Front plant most likely done by day 80-85, back left should be done by 85-90 and the back right might take 100