CannaGranny’s Corner a Thread For General BS and Good Will On BudBuilders

[ninjadip]

No leak trail? Seal, connection or pin hole somewhere. You’ll get it.

Oh i found it, def water pump, either the seal to the block or to the transfer pipe. Just no time to work on it until tomorrow

Craziest thing only leaks when not under pressure, which leads me to believe is bad seal, o-ring, or the transfer pipe needs to be reseated. First going to check if water pump bolts need to be retorqued as that is easier access before checking transfer pipe which requires removal of thermostat housing and intake manifold and is a pita

Outside of that, happy Friday!

 

[ninjadip]

No leak trail? Seal, connection or pin hole somewhere. You’ll get it.

I'm loving the intake temps with new intercooler, getting as low as 2 degrees farenheit above ambient, pretty pretty coooool!

 

[Zen_seeker]

I'm loving the intake temps with new intercooler, getting as low as 2 degrees farenheit above ambient, pretty pretty coooool!

My Jeep used to get hot especially when mudding or off-roading for a while. It had a rad fan with a spring clutch. I had enough and went to drill a hole through it to put a bolt in and lock it down. The bit broke off and jammed in flush. It held for years and still kept much cooler that before. Kept warm in winter too. Sometimes we get lucky.

 

[Zen_seeker]

 

[GoodShit97]

Happy friday yall.
Ive been MIA lately, between work, baseball for 2 kids, martial arts, and daily life i have no time for anything anymore lol.
Finally got a new 4x4, a bunch of new clones, and am ready to rock and roll again.

 

[steamroller]

Happy Friday all~!

 

[steamroller]

Morning, cool horse event going on in horse country here in va

I love watching the horses warm up/ practice early in the morning.
They just did the third and final Belmont stakes here.
Pretty cool watching the horses and people.

 

[GoodShit97]

 

[Stoneyluv]

happy friday right back to y' all!!