Red's Thread ~ All things Cannabis

[Observer]

I suppose if I wanted a couple grams per plant and did bonsai. No friggin way 15 plants will fit in there until flower. Even with just 1 the roots would get all caught up in the fan and other hardware.

I’m sure you would find a way to make it work tho.

For me I’ll stick to the 4x8 fog tent with the 4 55 gallon totes to flower in via fog. Leave the cloner to be a cloner/seedling starter.

View attachment 92903
That’s a proper fog flower setup

OCD triggered.

 

[Observer]

moe

 

[moe.red]

i got youre DWC and FOG tents mixed up, thinking you only had the fog cloner and RDWC for flower.

and guess i forgot about the actual fog tent for flower, cause of the RDWC vid above.

so now i meant, when the next fog flower run?

the plants coming from the fog cloner and going into the RDWC confused me for a second there, my bad, thought it was a fog run you were going to do not a RDWC.

Yeah I got this set up so I can move these netpots anywhere I want.

I have 3 4 x 8 tents plus the 2x4 fog cloner and the aero cloner spots.

I’m struggling with the o2 stuff a bit. I need to get that sorted before I go back into fog flower. The do probe quits working after a few days due to buildup. I need to engineer a dunking system so I can pull the probe out of the nute water when I am not reading.

I’ll get there just takes time.

Or I could do an atmospheric fog grow I suppose. I just really want to do o2 that’s why I built this system.

 

[Observer]

"
Automated Dunking:

• Servo/Actuator: Use a servo motor or linear actuator controlled by a timer or Arduino to raise/lower the probe.
• Timer/Arduino: Set intervals for readings and dunking."

seems like something you could do easily?

 

[moe.red]

OCD triggered.


View attachment 92998

Me too.

 

[Observer]

Manual Dunking:

• Simple: Use a sliding holder on a vertical rail to lift the probe when not in use.
• Materials: PVC pipe, plastic holder.

3D print a rail, run a litttle motor and gear? hot glue to side?

 

[moe.red]

"
Automated Dunking:

• Servo/Actuator: Use a servo motor or linear actuator controlled by a timer or Arduino to raise/lower the probe.
• Timer/Arduino: Set intervals for readings and dunking."

seems like something you could do easily?

I have testing to do. But yeah I’ll figure it out.

 

[moe.red]

Friggin inkbird rh sensor shit the bed. Humidifier ran all day.


Tent is raining.

Grrrr

 

[moe.red]

Got the tent dried out, back on track. Plants didn't seem to care. Growing fast, I'm about ready to flip these seedlings already lol