Grump's Indigo Sapphire Grow 🌱

[steamroller]

"Dry lumber" reads between 6-14%, with 6-8% being for interior wood work just for reference.

 

[GrumpAzz]

"Dry lumber" reads between 6-14%, with 6-8% being for interior wood work just for reference.

And from what I gather.. 10-12% is around ideal for nugs

I haven't played with mine yet on this harvest. Last one seemed to be about right when I threw it in the grove bags at 12%. They were funky nugs and it was hard to get a good reading though.

I'm also looking forward to storing in the trol. Grove bags in a dry basement won't keep the byds fresh. They dry out in a couple weeks. I suppose I should get me some bovedas.

 

[TomH]

I bought a couple wood moisture meters for testing my grows.

Used it once or twice on weed, but have tested every wall and piece of floor molding in the entire house

 

[GrumpAzz]

Found mold...

That means the whole load is trashed, eh?

13.5 ounces off of the two plants. Damn shame.

 

[steamroller]

Mold on a couple buds or most all?
What were the last readings from the cannatroller?

 

[GrumpAzz]

Mold on a couple buds or most all?
What were the last readings from the cannatroller?

Obvious mold on a couple buds but I didn’t inspect them all. Third tray down before I noticed and then I found anouther on the bottom tray. It's all stuffed in Grove bags for now.

I did factory settings and kept it on the dry cycle for 2 extra days. It never saw below 70%. Then I ran the cure cycle a day long. It finally got below 65% in the last 2 days and was sitting around 62% when I pulled everything.

I wafted the door a couple time a day and even pulled the trays all the way out when I went into cure.

Does bleach take out mold? I emptied the thing so I could chop my remaining plants. Looks like I'll be hand drying one so I don't stuff the thing too full this time.

 

[Stoneyluv]

did they feel "crunchy" when you put them in the bags?

you didn't harvest it all yet?? if not do a peroxide wash on them, that is now and will forever be in my routine of harvest. and twice on anything outdoor!

 

[OLDCRO]

Could those buds already have mold on them before going in to the cannatrol. Just a question

 

[steamroller]

Really sounds like something wasn't working right.
5 days should have had you at 62% before cure.
Not sure if new model runs the same as old.

 

[GrumpAzz]

did they feel "crunchy" when you put them in the bags?

you didn't harvest it all yet?? if not do a peroxide wash on them, that is now and will forever be in my routine of harvest. and twice on anything outdoor!

Nah not crunchy. 10 days in the Cannatrol and then into the bags for storage while I chopped the other plants.

They feel done and smoke great. Wife just said "well should we roll a moldy"

Been smoking samples for a couple days now. No mold on anything we've pulled out yet. Just when I emptied the whole thing.

Could those buds already have mold on them before going in to the cannatrol. Just a question

There's a possibility. I didn't see any signs beforehand, though. I usually have a pretty good eye and mold wigs me out so it has me extra paranoid with the fattest nugs.

I'll look real close when I chop the next two plants tomorrow. I'll probably only put one in the trol this time.

Really sounds like something wasn't working right.
5 days should have had you at 62% before cure.
Not sure if new model runs the same as old.

Man it was stuffed to the max. Like puzzle-pieced in there. I don't know what 13.5 dry equates to wet, but I know it's WAY ovwr their 2.2 pound recommendation.

 

[steamroller]

Man it was stuffed to the max. Like puzzle-pieced in there. I don't know what 13.5 dry equates to wet, but I know it's WAY ovwr their 2.2 pound recommendation.

Yea roughly you may have been 1 lb over the limit.

Be real careful smoking it.
You got enough to chuck whatever is questionable.

 

[Stoneyluv]

ozone or UV it?

 

[steamroller]

ozone or UV it?

I thought I had heard of extracting with alcohol being the only safe recourse, but upon search I found nothing.
Maybe I didn't look properly.

 

[Stoneyluv]

personally i'd just ditch it.. but not everybody has a giant cooler full of weed.

 

[GrumpAzz]

Be real careful smoking it.
You got enough to chuck whatever is questionable.

Yeah. It's all in 4 bags. I'll keep watch and will likely chuck it unfortunately.

personally i'd just ditch it.. but not everybody has a giant cooler full of weed.

Yeah for sure. Hate to get sick being stingy

 

[Observer]

Yeah. It's all in 4 bags. I'll keep watch and will likely chuck it unfortunately.


Yeah for sure. Hate to get sick being stingy

You make extracts or fresh frozen

Or say fuck it and Smoke it

Going off of particle and wave theory science....that shit is everywhere...already anyways.....

Fire destroys most.....I think..

But keyword.....most....

 

[Observer]

Yeah. It's all in 4 bags. I'll keep watch and will likely chuck it unfortunately.


Yeah for sure. Hate to get sick being stingy

I'm sure you have options though...

 

[GrumpAzz]

You make extracts or fresh frozen

Or say fuck it and Smoke it

Going off of particle and wave theory science....that shit is everywhere...already anyways.....

Fire destroys most.....I think..

But keyword.....most....

Half the harvest is suspect...

The other half should end up fine. 1 plant went in the Cannatrol and the other is hanging in the tent the same way I used to dry. The Trol is half a packed as the last attempt so I think we should be golden. The stuff in the tent is what it is with no temp control. It'll be fine.

We've been breaking apart nugs with eagle eyes. If I find a bit of mold, we toss the whole nug and try again. So far I've only found 1 moldy nug that made it into the smoking jar. We'll risk it until this next batch dries. Fuck it.

 

[Stoneyluv]

ehh use a crack lighter.. you'll be fine!!

 

[Observer]

Half the harvest is suspect...

The other half should end up fine. 1 plant went in the Cannatrol and the other is hanging in the tent the same way I used to dry. The Trol is half a packed as the last attempt so I think we should be golden. The stuff in the tent is what it is with no temp control. It'll be fine.

We've been breaking apart nugs with eagle eyes. If I find a bit of mold, we toss the whole nug and try again. So far I've only found 1 moldy nug that made it into the smoking jar. We'll risk it until this next batch dries. Fuck it.

Ok

That's okay

If the individual nug is not compromised then okay, disregarding particle and wave theory.


But if you don't feel comfortable then just trash it or extract it.

Otherwise, smoke that shit, Homie.

Correct the Mistakes Next Time.

 

[Observer]

You can run high humidity, they are tropical plants.

But clean environment for indoors, and sufficient airflow.

I can say upgrade you're air flow power

Or we can look at you're room dimensions, math out the CFM, correlate to proper VPD for high growth rate cannabis

 

[Observer]

I thought I had heard of extracting with alcohol being the only safe recourse, but upon search I found nothing.
Maybe I didn't look properly.

Yeah, you can definitely extract it and separate and purify

 

[Observer]

ozone or UV it?

It'll kill it, but the material is still there. If you wanna smoke it lol

 

[GrumpAzz]

You can run high humidity, they are tropical plants.

But clean environment for indoors, and sufficient airflow.

We don't get any other mold in the basement. Two dehueys running full time and it stays 35-45% down there.

I can say upgrade you're air flow power

Or we can look at you're room dimensions, math out the CFM, correlate to proper VPD for high growth rate cannabis

Airflow isn't my issue. The tent is fine. It's just the plants I chopped and put in the Cannatrol. I went way above recommended weight and the Trol couldn't keep the humidity down. Found 3 nugs with obvious mold as I was unloading it for the next round. Found mold in one of the nugs we've brought up for smoking. I'm keeping a watchful eye on anything that gets broken up now.

The Grow was on point this round. I just flubbed the dry by packing the Cannatrol too full. It's gonna be a wasted investment if it'll only do one plant at a time...

 

[Stoneyluv]

We don't get any other mold in the basement. Two dehueys running full time and it stays 35-45% down there.


Airflow isn't my issue. The tent is fine. It's just the plants I chopped and put in the Cannatrol. I went way above recommended weight and the Trol couldn't keep the humidity down. Found 3 nugs with obvious mold as I was unloading it for the next round. Found mold in one of the nugs we've brought up for smoking. I'm keeping a watchful eye on anything that gets broken up now.

The Grow was on point this round. I just flubbed the dry by packing the Cannatrol too full. It's gonna be a wasted investment if it'll only do one plant at a time...

a little extra prevention you can do next time is also let the buds dry a little extra before the grove bags. i found mine turns out the best when i bag it up after i think it's too late almost. like i feel the buds and think damn i might have over dried.. when i get that feeling thats when my cures turn out the best.

you buds should be dry enough that it makes a tiny mess on the table from you bagging it up. crispy or crunchy is the way i would describe it.