Pipecarvers Pipes & things

[Pipecarver]

So I mixed it again using the same ingredients: 3 ml silicone, and then 10 ml of each for a total of 33 ml in a gallon of water that was 130 PPM out the tap

Got 171 × 10 = 1710ppm
(@6.6pH)

Virtually the same result as the last time View attachment 118686

10 ml of each M,G.B....wow that's a lot, 2nd week in flower for me -I don't use silicon but my mix would be 5/5/8/5/4 ml/gal with added Diamond Nectar & KoolBloom liquid With ppm somewhere around 900-1000/ 3rd week I start with Cal/mag I don't usually read my ppm but i doubt it gets over 1200 at any time. My well water is around 120ppm.

 

[Pipecarver]

You getting back to your pens & pipes this winter? Maybe try some abstract art?

I hope to, I glued the magnets on your other 2 cats last night. They all hang now above their bowls on the fridge. Its the perfect spot for my 3 boys. It was an empty white wall. My camera is down stairs I'll take a pic this afternoon after I check my plants.

I cleaned up my workbench the last few days so I have access to all of my tools and a bit of space to use them. Its right next to my drying box though so no dust until I have everything bagged up and curing.

I have an issue with my radiator in the box. I checked yesterday and the res was 64f wtf its set at 51f. The pump running 24/7 gets too warm in too little water ( i Only added 6 gal) and it runs through a filter I use with the autopots. Its cool before the filter and warm after the filter so the filter is restricting the flow too much. Its not needed but I now need a connector to remove the filter and hook the 2 lines back up. Always something.